Enterasys 2S4082-25-SYS Instalační příručka stáhnout pdf (Strana 67)

Overview of the NAC Controller PEP Shutdown Procedure

Enterasys NAC Controller Hardware Installation Guide 5-7

Recommended Shutdown Procedure

BeforepullingaNACControllerPEPoutofachassis,

pressortaponits

OFFLINE/RESETswitchforlessthan1 second.

ItsCPULEDchangesfromsolidgreentoblinkingbetweengreenandamber,indicatingthatthe

moduleisshuttingdown.Attheendoftheshutdownroutine,theCPULEDchangestoa

67%/33%sequenceofamber/off,respectively,indicatingthemoduleisinahalt

state.Inthistimeit

issafetorestartorremovethemodulefromthechassis.

Whenacontrolledshutdownisinitiatedfromthe

OFFLINE/RESETswitch,youhave60seconds

fromthetimetheCPUstartsalternatelyflashingamber/offuntilthedeviceautomaticallyrestarts.

Last Resort Shutdown Procedure

ToresetaNACControllerPEPwithoutitperforminganorderlyshutdownroutine,

pressandholdthe

OFFLINE/RESETswitchforapproximately6seconds.

PullinganyNACControllerPEPoutofthechassisbeforeithasbeenshutdownisnot

recommended.Theonlysafetimetopullamoduleoutofthechassisisafterthecompletionofa

shutdownandthemanagementLEDisalternatelyflashingamber/off.

Caution: Do not remove a NAC Controller PEP from an operating chassis system before reading

the following information and instructions.

Precaución: Antes de retirar los módulos DFE del chasis en funcionamiento, lea las siguientes

instrucciones y la información suministrada.

Note: The only safe time to pull a chassis out of the chassis is when the CPU LED is alternately

flashing amber/off. Otherwise, system operation will be interrupted.

Caution: This method of shutting down a NAC Controller PEP is not recommended except as a last

resort, because all processes currently running on the module will be interrupted resulting in loss of

frames.

Precaución: No se recomienda utilizar este método para apagar los módulos DFE. Recurra a él

sólo como último recurso, puesto que interrumpe todos los procesos del módulo en

funcionamiento, lo que podría resultar pérdidas de frames.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 107 108

Žádné komentáře

Enterasys 2S4082-25-SYS Instalační příručka Strana 67