Enterasys 2S4082-25-SYS Instalační příručka stáhnout pdf (Strana 56)

Connecting to COM Port for Local Management

4-16 NAC Controller PEP Installation

Figure 4-13 Connecting a VT Series Terminal

Connecting to a Modem

ToconnectamodemtoanEnterasys NetworkschassisCOMport(Figure 4‐14),useaUTP

straight‐throughcablewithRJ45connectorsandanRJ45‐to‐DB25maleadapter,andproceedas

follows:

1. ConnecttheRJ45connectoratoneendoftheUTPstraight‐throughcable

totheCOMportof

themodule.

2. PlugtheRJ45connectorattheotherendoftheUTPstraight‐throughcableintothe

RJ45‐to‐DB25modemadapter.

3. ConnecttheRJ45‐to‐DB25adaptertothecommunicationsportonthemodem.

4. Turnonthemodem.

5. WithaPCconnectedtoaremotemodem,

youcanconfiguretheswitchremotely.To

accomplishthis,youmustconfigureyourPCVTemulation packagewiththefollowing

parameters:

6. Whentheseparametersareset,theLocalManagementpasswordscreenwilldisplay.Referto

theEnterasysMatrixDFE‐Diamond/PlatinumSeriesConfigurationGuideforfurtherinformation.

1 UTP straight-throughcable with RJ45 connectors 3 RJ45-to-DB25 VT adapter

2 RJ45 COM port 4 VT series terminal

Parameter Setting

Mode 7 Bit Control

Transmit Transmit=9600

Bits Parity 8 Bits, No Parity

Stop Bit 1 Stop Bit

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 107 108

Žádné komentáře

Enterasys 2S4082-25-SYS Instalační příručka Strana 56