Enterasys ANG-3000 Uživatelská příručka Strana 237

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 414
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 236
XSR Users Guide 203
Chapter 9 ISDN (ITU Standard Q.931) Call Status Cause Codes
Configuring Integrated Services Digital Network (ISDN)
BRI Leased Frame Relay
The following example configures Frame Relay service over a multipoint
leased BRI connection. For more information on Frame Relay, refer to
“Configuring Frame Relay” on page 119.
XSR(config)#interface bri 1/0:1
XSR(config-if<BRI-1/0:1>)#no shutdown
XSR(config-if<BRI-1/0:1>)#encapsulation frame-relay
XSR(config-if<BRI-1/0:1>)#frame-relay lmi-type none
XSR(config)#interface bri 1/0:1.1 multi-point
XSR(config-if<BRI-1/0:1>)#ip address 2.2.2.2 255.255.255.0
XSR(config-if<BRI-1/0:1>)#frame-relay interface-dlci 16
XSR(config-if<BRI-1/0:1-16>)#no shutdown
ISDN (ITU Standard Q.931) Call Status Cause Codes
The XSR supports the following Q.931 Cause Codes:
Table 9 Call Status Cause Codes
Code Cause
0 Valid cause code not yet received
1 Unallocated (unassigned) number
2 No route to specified transit network (WAN)
3 No route to destination
4 Send special information tone/Channel unacceptable
5 Misdialed trunk prefix
6 Channel unacceptable
7 Call awarded and being delivered in an established channel
8 Prefix 0 dialed but not allowed
9 Prefix 1 dialed but not allowed
10 Prefix 1 dialed but not required
Zobrazit stránku 236
1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 413 414

Komentáře k této Příručce

Žádné komentáře