Enterasys ANG-3000 Uživatelská příručka stáhnout pdf (Strana 48)

100

101

14 XSR User’s Guide

Utilizing the Command Line Interface Chapter 2

Managing the XSR

Exiting From the Current Mode

Each of these commands exits from your mode but with different results:

 Exit: In each mode

exit quits from the current to previous mode

 End:

end always returns to Privileged EXEC from either Global or

sub-configuration mode

 Ctrl-Z: Same as the

end command

 Be aware that you need not always exit from a mode if your current

and destination modes subscribe to the same parent in the mode tree.

Mode Examples

Consider the following examples to change configuration mode:

XSR>enable + Acquires Privileged EXEC mode

XSR#config terminal + Acquires Global configuration mode

XSR(config)#interface fastethernet 1 + Acquires Interface mode

XSR(config-if<F1>)#ip address 192.168.2.2.255.255.255.0

Sets up the IP address and subnet mask for this FastEthernet port

XSR(config-if<F1>)#exit + Quits Interface mode

XSR(config)#exit + Quits Global mode

XSR#disable + Quits Privileged EXEC mode

XSR> + Returned to EXEC mode by previous command

Observing Command Syntax and Conventions

The CLI command syntax and conventions use the notation described below.

Table 4 CLI Syntax

Convention Description

xyz

Key word or mandatory parameters (bold)

[x] [ ] Square brackets indicate an optional parameter (italic)

[x | y | z] [ | ] Square brackets with vertical bar indicate a choice of values

{x | y | z} { | } Braces with vertical bar indicate a choice of a required value

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 413 414

Komentáře k této Příručce

Žádné komentáře

Enterasys ANG-3000 Uživatelská příručka Strana 48

Komentáře k této Příručce