Enterasys ANG-3000 Uživatelská příručka Strana 128

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 414
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 127
94 XSR Users Guide
Configuring RIP Examples Chapter 5
Configuring IP
SNMPv3 MIBs including:
RFC-3411 Framework
RFC-3412 MPD
RFC-3414 USM
RFC-3415 VACM
Configuring RIP Examples
The following example enables RIP on both FastEthernet interfaces and a
serial link of the XSR. The FastEthernet 2 interface is configured to be totally
passive (updates not sent or received).
The serial interface uses split horizon with poison reverse while the others use
split horizon (the default). Authentication mode text is used on Serial 1/0,
and the key string is Mexico:
XSR(config)#interface fastethernet 1
XSR(config-if<F1>)#ip address 192.168.1.1 255.255.255.0
XSR(config-if<F1>)#no shutdown
XSR(config)#interface fastethernet 2
XSR(config-if<F2>)#no shutdown
XSR(config-if<F2>)#ip address 192.169.1.1 255.255.255.0
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#ip address 192.5.10.2 255.255.255.0
XSR(config-if<S1/0>)#ip split-horizon poison
XSR(config-if<S1/0>)#ip rip authentication key-string Mexico
XSR(config-if<S1/0>)#ip rip authentication mode text
XSR(config-if<S1/0>)#encapsulation ppp
XSR(config-if<S1/0>)#no shutdown
XSR(config)#router rip
XSR(config-router)#network 192.168.1.0
XSR(config-router)#network 192.169.1.0
XSR(config-router)#network 192.5.10.0
XSR(config-router)#passive-interface fastethernet 2
XSR(config-router)#no receive-interface fastethernet 2
The following RIP example sets an Access Control List (ACL) to allow packets
from the address of 192.168.1.xxx and 154.68.1.xxx (where xxx are any valid
numbers) only through the XSR's FastEthernet 1 port.
Zobrazit stránku 127
1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 413 414

Komentáře k této Příručce

Žádné komentáře