Enterasys 2E253-49R Uživatelská příručka Strana 295

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 390
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 294
Network Tools
Network Tools Screens 11- 3
Refer to Table 11-1 for a list of the commands.
Special Commands – Allow the user to exit from Network Tools. The commands are done, quit,
and exit.
The commands are presented in the following format:
Table 11-1 Built-In Commands
alias arp arp_learn atm_stp_state
1
1. The atm_stp_state command only displays when an HSIM or VHSIM is installed that supports ATM, such as the
HSIM-A6DP or VHSIM2-A6DP.
bridge cdp defroute dynamic_egress
ev gigabit_port_mode
2
2. The gigabit_port_mode command only displays when a gigabit interface module is installed.
igmpv3_drop lg_frame_admin
link_trap loopback_detect maclock netstat
non_bridge_if_num passiveStp ping policy
radius rate_limit_mode reset sat_size
show soft_reset stpEdgePort stpForceVersion
stpLegacyPathCost stpPointToPointMAC stpPort stpRealTimeMsgAge
suppress_topology_
traps
telnet timed_soft_reset timed_reset
traceroute vrrpPort
NOTES: The conventions used in describing the commands in Network Tools are as
follows:
Arguments enclosed by [ ] are required.
Arguments enclosed by < > are optional.
In the following command examples, the information entered by the user is shown in
bold font
.
To abort the output or interrupt a process, press the CONTROL key and c key
simultaneously, designated as ^C here.
Zobrazit stránku 294
1 2 ... 290 291 292 293 294 295 296 297 298 299 300 ... 389 390

Komentáře k této Příručce

Žádné komentáře