Enterasys Enterasys SecureStack B2 B2G124-24 Instalační příručka stáhnout pdf (Strana 42)

Configuring Switches in a Stack

3-14 Hardware Installation

Recommended Procedures for New and Existing Stacks

Installing a New Stackable System of Up to Eight Switches

Usethefollowingproceduretoinstallanewstackofuptoeightswitchesoutofthebox.

Beforeapplyingpower,makeallphysicalconnectionswiththestackcablesasdescribed

in“ConnectingHigh‐SpeedStackingCables”onpage 3‐10.

1. Onceallofthestackcableshavebeenconnected,individually

poweroneachswitch

fromtoptobottom(connectingpowertoaswitchisdescribedin“ConnectingACand

RPS‐SYSPower”onpage 3‐15).

Iftheswitchesarepoweredonalmostsimultaneously,thesystem willautomatically

selectthefirstonethatpowersupastheMasterswitchand

theothersasMember

switches.TheswitchesareassignedunitIDsintheorderthattheybecomefully

operational.

YoucancontroltheunitIDassignmentaccordingtothephysicalpositioninastack.

Whenyoupowerupeachswitchandallowittobecomefullyoperationalbefore

applyingpowerto

thenextswitch,thefirstonebecomestheManagerandallthenext

switcheswilljointhatstack(regardlessofPriority,FirmwareRevision,orMAC

Address).TheswitchesareassignedunitIDsintheorderthatyoupoweroneach

switch.

2. (Optional)Ifdesired,changethemanagementswitchusingtheset

switch

movemanagementcommandasdescribedintheSecureStackB2ConfigurationGuide.

3. Oncethedesiredmasterswitchhasbeenselected,resetthesystemusingthereset

commandasdescribedintheSecureStackB2ConfigurationGuide.

Important

The following procedures assume that all switches have a clean configuration from manufacturing.

When adding a new switch to an already running stack, it is also assumed that the new switch is

using the same firmware image version as other switches in the stack.

Note: Once switch IDs are assigned, they are persistent and will be retained during a

power cycle to any or all of the switches.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 77 78

Žádné komentáře

Enterasys Enterasys SecureStack B2 B2G124-24 Instalační příručka Strana 42